A: No. The ET97 is a standard multimeter, not a clamp meter. You must break the circuit and connect the meter in series to measure current.
Leave a comment below, or reach out to Mac Tools directly. And if you found this guide helpful, consider sharing it with a fellow technician who just bought their first ET97. Disclaimer: This article is for informational purposes. Always refer to the official Mac Tools ET97 User Manual for safety warnings and device-specific instructions. Product designs and specifications may change over time. Mac tools et97 user Manual
A: According to standard multimeter safety, you need CAT III 600V or better leads with right-angle banana plugs to fit the recessed jacks on the ET97. Mac Tools part number is likely MACET97TL or a universal set like MACLT100A . Leave a comment below, or reach out to Mac Tools directly